05-14-2015, 01:09 AM
(05-14-2015, 12:47 AM)doveman link Wrote:Are you just testing with the cable or using BT? You should be able to get data to show in the serial monitor if you edit the appropriate lines to print (or is it serial.print). Have you flashed the calibration sketch? I guess you should still get data even if you haven't calibrated yet but I recall it was gibberish for me until I did that.
Problem is, I get a total hangup of the Arduino IDE when I try to send anything... receiving works, I can add debug output etc.
Unfortunately, the sensor data seems to be nonsense. As I said, I don't get any LED on the GY-85