05-15-2015, 12:19 PM
Geez, I'm going insane with this thing.
For the record, using the USB only variant for now, using this software: http://sourceforge.net/projects/gy80face...p_redirect
So first thing is to flash the calibration sketch, which I do. It actually works, I can see the values changing in the calibration GUI. The plot function does not show any changes, though.
Then I load the facetrack sketch, and if I just check with a serial terminal, I see a lot of unprintable characters appearing. But FaceTrack NOIR doesn't work at all....
sigh... need to look at the sketch itself
For the record, using the USB only variant for now, using this software: http://sourceforge.net/projects/gy80face...p_redirect
So first thing is to flash the calibration sketch, which I do. It actually works, I can see the values changing in the calibration GUI. The plot function does not show any changes, though.
Then I load the facetrack sketch, and if I just check with a serial terminal, I see a lot of unprintable characters appearing. But FaceTrack NOIR doesn't work at all....
sigh... need to look at the sketch itself